Troubleshooting; Handle Power2Go Safely - Bmz Power2Go Work Bedienungsanleitung

Before connecting the AC power supply device, make sure that the voltage and power
⚫
of the device are consistent with the output voltage and frequency of the POWER2GO .
⚫ It is forbidden to connect the AC output of the POWER2GO with its own AC input,
otherwise the POWER2GO will be damaged.
⚫ Without any AC and DC output for 30 minutes, the POWER2GO will automatically turn
OFF and enter a low-power mode. During this event, you need to press again the main
switch to bring the POWER2GO to active mode again.
EN
⚫ POWER2GO supports simultaneous charging and discharging, i.e. UPS function. When
input and output power is in max load the charging power will automatically be decreased
so total bypass power will not be that big to trigger the product and home fuse breaker.
⚫ When the main power switch is turned OFF, the AC, DC, and LEDs are turned off at the
same time.

8. TROUBLESHOOTING

State
LED red display
LED red display
LED red display
LED red display
LED red display

9. HANDLE POWER2GO SAFELY

9.1 POWER2GO cannot be opened under any circumstances, and repairs can only be carried
out by professionally trained personnel.
10
LED
Operating
Conditions
An issue was detected.
Charge
(Overvoltage Protection)
An issue was detected.
Charge (Charging over-temperature
protection)
An issue was detected.
Discharge
(Overload Protection)
An issue was detected.
Discharge
(SOC low)
An issue was detected.
Discharge
(Low Voltage Protection)
Possible Causes Solution
Remove all charging and
discharging connections and
restore after restarting the device
Automatic recovery when the
battery cools down
Remove the overpowered device
and restart the POWER2GO to
recover.
(Use devices that are within the
rating range of the POWER2GO)
Charge POWER2GO or reduce
the load power
Charge P2GO