Ac Charge - Bmz Power2Go Work Bedienungsanleitung

7.1 AC Charge

In the state of power ON or OFF, you can charge the POWER2GO AC, directly plug in the AC
charging cable, the internal circuit starts charging in about 3 seconds of self-test, and LED
will automatically light up to display the charging status through light bar ratings.
Note:
⚫ Insert the charging socket to POWER2GO charging port first before plugging it to the
mains.
⚫ When the SOC shows 100%, the actual charging process is over. It is advisable to
extend the charging time during your first charging process. This allows the device to do
self-calibration.
⚫ AC charging power is gradually increasing every minute and will stabilize when
maximum charging power is reach.
EN
Protection
EN
7