Customizing Brightness Levels; Default Setting - Lupine Betty R Bedienungsanleitung

4
Customizing the brightness levels
You have the option to setup to 4 brightness
1.
Press and hold the button (for approx. 4 seconds) until one
release the button

2.
The range of brightness levels you can select will
3.
Press the button at the brightness level you want.
the first power-on click is presented

4.
Upon releasing the button, the sequence
of brightness levels automatically
restarts, allowing you to set a second
level in the same manner as the first click
set-up. This process can be repeated up
to four times, but will stop when you quit
making further selections, thus allowing
your light to operate in 1-step, 2-step,
3-step,-or 4-step modes.
* If in use, shown by green LED
** Will not be signalised by status LED
In special version with XP-E LED 0.8W
4 0 Betty R
levels, in any sequence
green LED lights up.
begin automatically to cycle, as shown below.
1 W
brightness level
2 W
brightness level
4 W
brightness level
8 W
brightness level
12 W
brightness level
16 W
brightness level
22 W
brightness level
28 W
brightness level
34 W
brightness level
45 W
brightness level
SOS*
RVLR*
Alpine SOS*
Flash*
0.3W Center-LED **

Default setting

Default setting:
1. brightness level
2. brightness level
3. brightness level
Recover factory settings:
1.
Press and hold the button until 5 red
release the button

2.
Disconnect the battery, and all factory settings will be restored.
3.
Reconnect the transmitter with the lamphead see page 39.
SOS:
SOS will continue until the battery is empty. Improper use of the SOS
signal is punishable by law.
RVLR:
This mode includes an additional slow flash mode.
Alpine SOS:
Alpine SOS will continue until the battery is empty.
signal is punishable by law.
Flash 15hz: (Disorientation)
This mode is extremely irritating and may by no means be misused.
Center:
Low beam made by the center LED only.
22 W
45 W
2 W
LEDs turn on.
Improper use of the SOS
Betty R
4
41