Inhaltsverzeichnis
Werbung
and it can deliver 2.5 A current. When connecting another adapter to
your P200-LCD, make sure it is provided with a 5.5/2.1 mm output
connector (plus inside, minus outside).
Charging of batteries
• Select the type of inserted batteries via the selector (5). In the
case of NiMH batteries, put the selector in the centre position, of
NiCd batteries to the left-limit stop and of RAM cells to the right-
limit stop.
If you charge different types of cells simultaneously
or, if the selector switch has been positioned
incorrectly, it could destroy the device and the
batteries!
• Insert the rechargeable batteries into the charging shafts (1). You
can recharge 1 to 4 cells at the same time. When charging Micro
and Mignon cells, you can additionally charge one 9V block
battery in the charging shaft (6) that is intended for that purpose.
Do observe the polarity of the batteries. The correct
polarity is shown in the charging shaft.
• Now the battery charger automatically switches to the charging
mode. This mode is indicated by red flashing of the status LEDs
(2), which are over the respective charging shaft, and by the bar
display as well as by the "CHA" (for charge) indication on the
display (4). NiCd batteries will be discharged first – "DIS"
(discharge) is seen on the display, the charging of batteries is
indicated by the (orange) status LEDs. The charging of 9 V block
batteries is indicated by the flashing of the status LED (7).
• After the cells have been fully charged, the battery charger will
automatically switch to trickle charge. This will be indicated by the
green flashing of the status LEDs (2) which are over each shaft,
16
Safety instructions
In case of any damages which are caused due to
failure to observe these operating instructions,
improper operation or the failure to observe the safety
instructions, the guarantee will expire! We neither
assume liability for consequential damages nor for
damages to property nor personal injury!
An exclamation mark in a triangle points out important
instructions in the operating manual. Before putting
the device into operation, please read the operating
instructions completely.
• For safety and approval reasons the unauthorized conversion or
opening of the device is prohibited!
• Please charge via this device only Nickel Metal Hydride (NiMH)
and Nickel Cadmium (NiCd) batteries as well as rechargeable
alkaline batteries (RAM cells). Never recharge single-use
batteries.
• Never charge different types of batteries (NiMH, NiCd or RAM).
The device can charge maximum 4 cells at a time. Simultaneous
charging of different types of batteries may lead to the leakage,
bursting of batteries and personal injury. Never short-circuit the
charging contacts or batteries! It is normal that batteries get warm
during the charging procedure. Please handle re-charged
batteries with care!
• The P200-LCD universal battery charger must not come into
contact with moisture or wetness.
• Neither the device nor batteries are toys for children. This is why
keep them out of reach of children!
• Never cover the ventilation slots of the device. Place the device
on a smooth and flame retardant surface.
13
Werbung
Inhaltsverzeichnis
