Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CHANGING BETWEEN NORMAL TIME
AND CHRONOGRAPH
1.
When the
CHANGEOVER
normal time display, a confirmation sound is heard.
Then, the second hand quickly advances and stops at
the 0 position, showing the Chrono display.
2.
When the
CHANGEOVER
Chrono display, a confirmation sound is heard.
Then, the micro-second hand, chrono minute hand
and chrono hour hand come to the 0 position and
the second hand changes into normal time.
CHRONOGRAPH
Set watch to chronograph display (see above).
TO START CHRONO:
1.
Push
START/STOP
to start Chrono. The micro-second
hand will run for three minutes after starting then
stops at "0". Don't worry, it continues measuring after
it stops. Counts up to 11 hr, 59 min, 59 sec.
2.
TO STOP CHRONO:
Push
START/STOP
while the Chrono is
running tostop.
Push
SET/RESET
to return to the 0 position.
3.
4.
The chronograph can be stopped and
restarted as much as you want by pressing
the
START/STOP
button.
button is pressed in the
button is pressed in the
USING THE CHRONOGRAPH
AS A COUNTER
Set to normal time display (see previous page).
You can count up to 50 by pressing the
1.
button repeatedly.
2.
After the counter is used, return the micro-second hand
to the "0" position by pushing
BATTERY LIFE INDICATOR
If the battery is near the end of its life, the second hand
changes from ticking every one second to ticking every two
seconds. Get battery replaced by a certified jeweler or call
Nixon at: (760) 944-0900.
GENERAL CARE
After using in salt water, shower with your watch on
or rinse with soap and tap water.
SET/RESET
CHANGEOVER
twice.
Werbung
Inhaltsverzeichnis
