Bosch POWER FOR ALL System AL 18 V-44 Originalbetriebsanleitung Seite 13

English | 13
The charger can be used either free-standing (for use on a desktop) or mounted on the
wall.
When affixing to the wall: Drill 2 holes, leaving a clearance of 56 mm. To secure it, use
round-head screws with a diameter of 5 mm to max. 6.5 mm.
Troubleshooting
Battery is not being charged
Battery is not being charged, the red indicator (3) is flashing and the green battery
charge indicator (2) is lit up continuously.
Cause: The charger has identified an internal error.
Corrective measure: Ensure that all batteries are fully inserted. Remove the mains plug
and reinsert. If the error occurs again, have the charger checked by an authorised after-
sales service centre for Bosch power tools.
Indicators do not light up
None of the indicators are lighting up, battery will not be charged.
Cause: Plug socket, mains cable or battery charger defective
Corrective measure: Check the mains voltage. If necessary, have the charger checked by
an authorised after-sales service centre.
Maintenance and Service
Maintenance and Cleaning
In order to avoid safety hazards, if the power supply cord needs to be replaced, this must
be done by Bosch or by an after-sales service centre that is authorised to repair Bosch
power tools.
After-Sales Service and Application Service
Our after-sales service responds to your questions concerning maintenance and repair of
your product as well as spare parts. You can find explosion drawings and information on
spare parts at: www.bosch-pt.com
The Bosch product use advice team will be happy to help you with any questions about our
products and their accessories.
In all correspondence and spare parts orders, please always include the 10‑digit article
number given on the nameplate of the product.
Bosch Power Tools 1 609 92A 8T5 | (17.08.2023)