Battery Change - Rottner Kyde Bedienungsanleitung

!!ATTENTION!! When using the power supply unit, no batteries must be inserted in the batte-
ry compartment !
a. Plug the power supply (8) into a 220 volt socket.
b. Connect the supplied power supply unit (8) to the plug connection (5).
c. The electronic lock is now ready to be programmed.
If you enter an incorrect code and press the "A" button, you will hear four acoustic sig-
If the red LED flashes several times when opening the door (with a stored code), you should
immediately change the batteries. Please use high-quality batteries.
a. Insert one of the two supplied cylinder keys into the lock (7).
b. Turn the key anti-clockwise until it stops.
c. Open the door.
d. Open the battery compartment (3).
e. Replace the four inserted 1.5 volt AA batteries with new, high-quality batteries
(make sure the polarity is correct when inserting the batteries).
f. Close the battery compartment.
g. Close the door.
h. Turn the key clockwise back to its original position and remove it.
ATTENTION: After changing the battery, the stored codes (master code, guest code) remain
2. COMMISSIONING WITH POWER SUPPLY
3. INCORRECT
nals and the yellow LED will flash four times.
4. BATTERY EMPTY WARNING

5. BATTERY CHANGE

intact.