Identification Of Parts; Assembly; Use Brush Cutter And Grass Trimmer - Texas A/S BCU 26 Bedienungsanleitung

!
Examine the tool for loose bolts and nuts, leakage etc. Replace any damaged parts. Replace the
trimmer head / blade if it is cracked, chipped or damaged in any other way.
!
Make sure that the trimmer head / blade is fitted correctly and securely fastened. If not this may lead
to serious personal injury.
!
Make sure that all safety guards and handles are correctly and securely fastened.
!
The cord head rotates while the carburetor is adjusted. Wear protection and follow all safety
instructions.
!
Let the engine cool off before storage.
!
Empty the fuel tank and fasten the brush cutter when it is transported.

Identification of parts

See fig.1 illustration:
A Engine
Throttle lever – Handle
B
*Only BCU26S and BCU33S models

Assembly

BCU 26 and BCU 33
Follow the mounting procedure as shown in Fig.2-A, Fig 2-B and Fig 3
1. Mount the protection guard. See Fig.2-A
2. Attach the middle tube to the machine, fasten with butterfly knob. See Fig 2-B
3. Mount the throttle lever and handle as shown in Fig 3 illustration A. Ensure that the machine is in
balance and bolt are tighten.
BCU 46
Follow the mounting procedure as shown in Fig.2-A and Fig 3
1. Mount the protection guard. See Fig.2-A
2. Mount the throttle lever and handle as shown in Fig 3 illustration A. Ensure that the machine is in
balance and bolt are tighten.

Use Brush cutter and Grass trimmer


When the engine is stopped the rotating blade must be held in grass or bush until it holds still.

Always hold the machine with both hands.

The machine must not be used if the safety guard is not correctly fitted and in mint condition.

Always stop the engine before attempting to remove objects that may have stuck on the blade.

Never touch or try to stop the blade while it is still spinning.

A rotating blade may cause damage, as it continues to spin after the engine has stopped or the gas
has been turned off. Always be in control of the tool until the blade has stopped spinning.

Always make sure that the blade is mounted securely and correctly before every time is used.

Only use a sharp blade. Replace blades that are worn or damaged.

Only use original spare parts.

Only use the blade for weeds, grass and similar.

Throw back is something that may occur when the rotating blade gets into contact with something, it
cannot cut. This contact may have the effect, which the blade stops for a moment, and suddenly the
tool is thrown away from the hard object that was hit. This reaction may be so violent that the user
loses control of the tool. Throw back may occur without warning if the blade is stuck, loses speed or
impeded. This is most likely in areas where it is difficult to see the material that is being cut.

The harness must always be used and adjusted to fit in the correct manner.

Keep a firm grip on both handles while the blade is running. Keep the blade away from your body
and below your waist.
Cutter – Trimmer
C Bracket E
D Guard F Tube with lock knob *
12