Start / Stop; Replacement The Trimmer Cord; Operation - Texas A/S BCU 26 Bedienungsanleitung

Refuel (Smoking prohibited)
!
Mix and store the fuel in containers that are approved for the purpose.
!
Mix the fuel outdoors where there are no sparks or flames.
!
Choose a bare place, turn off the engine and leave it to cool for 2 minutes before refueling.
!
Untighten the lid slowly to let out any pressure and to avoid that any fuel spills out under the lid.
!
Wipe off any spilled fuel. Move more than 3 meters away from the place where you put fuel on the
engine before it is started.

Start / Stop.

How to start a cold engine
1. Place the brush cutter on a flat surface.
2. Switch to" I ".
3. Press 8-10 times on the fuel pump located beneath the air filter.
Switch the choke in to start position see Fig.6-A
4. Activate the safety handle and press the throttle control, then lock the handle with the locking pawl.
Fig.6-B
5. Pull the starter until the engine runs.
Slide the choke lever to drive position when the engine starts to be warm
How to start a warm engine
Switch or ensure that the choke lever is set in driving position, see Fig.6-A
Pull the recoil starter until the engine runs.
How to stop the engine
1. Release the gas and the safety switch. Fig.6-B
2. Set the switch in the " O " position

Replacement the trimmer cord

Follow the procedure as shown in Fig.5
1. Stop the engine.
2. Press on each side of the line compartment. The lid may now be removed.
3. Dismount the roll simply by pulling it. Leave the spring (B), on the spool. Remove any bits of line.
Attach 3-4 meters of new line (2,4 mm) and place it double.
4. Fit each end of the line into a hole on the spool. Wind the two ends of line in the direction of the
arrow. Avoid twisting the line. Finally cut the double line at the middle. Fit the two ends through the
line controllers. Do not overfill the spool!
5. Mount the line compartment in reverse order. First, fit the spring into its position. Then place the line
in the two holes of the line compartment.
6. Finally mount the lid. Make sure that it is fitted securely.
Always make sure that the trimmer head is fitted securely. If in doubt ask your local dealer for advice.

Operation


High grass should always be cut from the top and downwards. In this way you prevent the grass
from being wrapped around the trimmer head and thereby lead to overheating and damage. If grass
and the like is wrapped around the trimmer head the engine must be STOPPED, the spark plug cap
taken off and the grass then removed.

For moving the line forward you tap the trimmer head lightly against the ground while the engine
runs at full speed.

Hold the trimmer at an angle towards the area that is to be cut.

The illustration shows the best cutting angle (Fig7A).

Use the line to cut. Do not force the trimmer head into grass that has not yet been cut.

Wire and fences are hard on the line and may even cause it to break.
Stones and walls, and wood cause the line to be worn down very fast. Walk around trees and bushes.
Bark and trees, wood boarding and poles are easily damaged by the line
14