EINHELL TE-PL 18/82 Li - Solo Sicherheitshinweise Seite 12

Special safety instructions
Always secure the workpiece if possible: Use
clamps or a vise to hold the workpiece securely.
This is far safer than holding it in your hand and
also means that you have both hands free to ope-
rate the electric tool.
Safety information for planes
•
Wait for the knife shaft to stop before you
put down the electric equipment. An expo-
sed rotating knife shaft can become caught
on the surface and result in loss of control
and serious injuries.
•
Hold the electric equipment only by the
insulated handles because the knife shaft
might strike the equipment's own power
cable. Contact with a live cable might also
make the metal parts of the equipment live
and cause an electric shock.
•
Use clamps or some other means to fas-
ten and secure the workpiece to a sturdy
surface. If you hold the workpiece only with
your hand or against your body it will remain
unstable and might cause you to lose control.
•
Ensure that there are no foreign objects
adhering to the workpiece in order to avoid
damaging the electric hand plane.
•
Hold the tool by its handle using both hands
and place the front base plate of the plane on
the workpiece. The base plates must evenly
rest on the workpiece during the planing pro-
cess.
•
Allow the tool to reach its maximum operating
speed before you start to plane.
•
Set the planing depth to 0 mm when you have
finished working.
•
Replace used planing knives with a set of
new knives when worn down.
•
Some types of planing knives have two bla-
des. When one blade has become blunt, the
planing knife can be turned over.
•
Blunt planing knives cannot be resharpened.
•
Always ensure that you replace both knives at
the same time.
•
Only the original, manufacturer-approved
knife block may be used for this electric hand
plane.
•
Always use only clean and sharp planing kni-
ves to ensure professional, safe results.
Do not lose these safety regulations.
SiHi_Akkuhobel_SPK13.indb 12 SiHi_Akkuhobel_SPK13.indb 12
GB
- 12 -
25.01.2021 14:51:10 25.01.2021 14:51:10