Manual Tuning - Philips Rc369 Bedienungsanleitung

WAVEBAND
e Briefly press the BAND key to select the
desired waveband. The display shows:
FM1, FM2, or FM3, MW1, or MW2, or LW
(when the Choice is set to 'EUROPE' under
'RADIO' option; see INITIAL SETTINGS).
FM1, FM2, or FM3, AM1, or AM2
(when the Choice is set to 'LATAM' or
'AMERICA' or 'ASIA' under 'RADIO' option;
see INITIAL SETTINGS).
SEARCH TUNING
Use search tuning to quickly search for a station.
e Briefly press the € key or P key.
— You will receive a station after a short time.
To search for another station, press the key
again.
SETTINGS; apie Option ow
the Choice to "OFF. a
sired station?
nan too weak, ae Manual
MANUAL TUNING (if you know the frequency
of the required station)
e Press the MANUAL key for at least 2 seconds
(until you hear a beep) to switch from search
tuning to manual tuning.
e Tune to the desired frequency with < and >
key (keeping the key pressed changes the
frequency quickly)
> =higher frequency
<= = lower frequency
Note: The radio automatically switches back
to search tuning after about 50 seconds with
a beep.
PRESET KEYS 1-6 (STORE AND PRESET)
Six stations per waveband can be stored and
recalled using the preset keys (1 to 6).
Storing a station
e Briefly press the BAND key to select the
desired waveband.
e Tune-in the desired station frequency.
e Press the desired preset key (1 to 6) for at least
2 seconds (until you hear a beep).
Note: A previously-stored station is
automatically erased if a new frequency is
stored on the preset.
Recalling a station
e Briefly press the desired preset key.
The display will show the band, frequency and
preset number.
AUTO STORE (AST)
You can automatically store 6 FM stations on
FM3 band or 6 AM(MW) stations on the
AM2(MW2) band by using AUTOSTORE (AST)
function. When you use Auto Store, the new
station replace any station previously stored in
the FM3 band or the AM2 (MW2) band.
Automatically storing stations
e Briefly press the BAND key to select the desired
waveband.
— Briefly press the AST key, you will hear a beep.
— The set mutes and display shows 'FM3 AST'
or 'MW2 AST' or 'AM2 AST".
— You will hear a beep when it has finished
storing 6 stations.
— You will hear the station on preset 1.
Sometimes it may not be possible to find six
stations. In this case, the remaining presets
are programmed with 0000 (radio mute). If no
stations are found, the previously stored
stations are maintained.
FREQUENCY SCAN
The scan function gives you a quick impression
of all the stations which can be received on the
current waveband. You hear each station in turn
for about 10 seconds.
e Press SCAN key for at least 2 seconds to
switch SCAN function on or off.