Philips RC369 Bedienungsanleitung Seite 3

INSTALLATION
If your car is equipped with ISO connectors,
simply insert them in connectors of the car radio.
If not, you can use an adaptor cable (Refer to
the table on the separate installation card).
PREPARATION
Voltage and polarity: The set must be connected
to a 12V car battery with negative terminal to
earth (car chassis).
Warning: To prevent short-circuiting, disconnect
the negative car battery terminal until the set
has been mounted and connected (fig.1). See
separate installation card.
CONNECTOR A (fig.2)
Recommended Power supply connections
¢ Red lead A7 : Connect to a switched 12V
supply (switched on/off by car ignition).
¢ Yellow/red lead A4 : Connect to a permanent
12V supply.
¢ Brown lead A8: Connect to earth (car chassis).
Alternative Power supply connections for
ON/OFF LOGIC (see illustration on separate
installation card for correct connection).
¢ Red lead A7 : Connect to a permanent 12V
supply.
¢ Yellow/red lead A4 : Connect to a switched
12V supply (switched on/off by car ignition).
¢ Brown lead A8: Connect to earth (car chassis).
e See INITIAL SETTINGS; select Option 'LOGI'
and set the Choice to 'ON'.
~ The ON/OFF LOGIC feature enables use of the
set (for one hour) after you have removed the
Car ignition key.
- The ON/OFF LOGIC feature in this set
functions only if your car has been prepared
for it (e.g. certain VW and Opel/Vauxhall cars).
Consult your car service manual or check with
your dealer to confirm this.
* only for certain versions
OTHERS CONNECTIONS (fig.2)
¢ Pink lead wire (Telephone mute) : If your car ©
telephone provides a mute signal, it can be
used to automatically interrupt the sets's |
audio output.
— Connect the telephone mute wire to Pink lead
wire (TEL. MUTE).
~— See INITIAL SETTINGS; select Option 'PHONE'
and set the Choice to 'LO' or 'HI' according to
phone type.
¢ Blue lead AS (Automatic Aerial) : This radio
can provide a 12V signal for the control of an
automatic motor aerial or the supply of an
electronic aerial by connection.
Do not use this connection for the supply lead
of the aerial motor!
¢ Orange lead A6: Connect to a 12V supply.
When the car headlamps are switched on, the
knobs of radio are illuminated (even when the
radio is switched off).
e Line-output *
You can connect a power amplifier (with 2 or
4* additional loudspeaker) to this set with the
RCA cable.
-— Connect Red socket to Right channel and
white socket to Left channel.
— Connect Blue wire to Amplifier Remote on/off.
CONNECTOR B (fig.2)
Loudspeakers (use 4 ohm loudspeakers only)
¢ Do not connect any of the loudspeaker leads
to earth or directly to a booster/amplifier.
¢ Connecting 4 loudspeakers
Front Rear
Left+ Green [B5] White [B7]
Left- Green/black [B6] White/black [B8]
Right+ Grey [B3] Blue [B1]
Right- Grey/black [B4] Blue/black [B2]