How To Program Or Erase The Remote - Topens Rk2600 Bedienungsanleitung

the CLOSE stall force of the gate opener.
Turn the potentiometer clockwise to increase the stall force.
Turn the potentiometer counter-clockwise to decrease the stall force.
WARNING: Photocell is highly recommended to be installed with the gate opener as entrapment
protection for safety when you set stall force to maximum.

How to Program or Erase the Remote

 The remote MUST be programed to the opener BEFORE OPERATING. Please follow the steps to
program the remote.
 Activate the opener only when gate is in full view, free of obstruction and properly adjusted. No one
should enter or leave gate area while gate is in motion. DO NOT ALLOW CHILDREN to operate push
button or remote. DO NOT ALLOW CHILDREN TO PLAY NEAR THE GATE.
 If you purchase additional remote controls, the gate opener must be programmed to accept the new
remote code.
 If you lose one of any remote control, please erase and reprogram all other remote controls to have a
new code for safety.
Program the remote
Press and release the learn button, the REM
LED light will be on, then press the key on the
remote two times in 2 seconds, between the
two times HOLD ON FOR A MOMENT, the
REM LED light will flash for 4 seconds. Now the
remote has been programmed successfully.
Erase all the remote codes
Press and hold the learn button until the REM LED light is off. Now all remote codes have been erased.
 NOTE: Max. 8 remotes can be programmed for the opener. An External Receiver (optional) allows up to
250pcs remotes to be programmed for the opener. TOPENS ERM12 Universal External Receiver is
available at TOPENS Store.
 TOPENS ERM12 Universal External Receiver is also compatible with other brand swing gate opener,
sliding gate opener and garage door opener.
35