Setting Of The Control Board - Topens Rk2600 Bedienungsanleitung

The RED wire of the motor should be connected into the "7" terminal.
The YELLOW wire of the motor should be connected into the "8" terminal.
2. Start Capacitor
One pin of the start capacitor should be wired to the "7" terminal, another to "8" terminal.
3. Limit Switches
The RED wire of the limit switches should be connected into the "9" terminal.
The BLACK wire of the limit switches should be connected into the "10" terminal.
The YELLOW wire of the limit switches should be connected into the "11" terminal.
4. Warning Light (Included in some models, refers to the actual package)
One wire of the warning light should be connected into the "4" terminal, another should be connected into the "5"
terminal.
5. Photocell Beam System (PBS) (NO) (Included in some models, refers to the actual package)
Use a 2-core cable to connect the "+ ~" terminal of the photocell's emitter to the "12" terminal, the "- ~" terminal
to the "13" terminal. Also the "+ ~" and "- ~" terminals of the photocell's receiver should be connected to the
"12" and "13" terminals in parallel.
Use another 2-core cable to connect the "NO" terminal of the receiver to the "14" terminal, the "COM " terminal
to the "15" terminal.
6. Push Button (Optional)
The push button should be wired to the "15" and "16" terminals. The gate opener works alternately by pushing
the button (open-stop-close-stop-open).
7. Exit Wand (Optional)
First insert the Adapter BOARD into the CONTROL BOARD, and then connect the wand to the control board
refers to following instruction.
The BLACK wire of the exit wand should be connected into the "#18" terminal.
The BLUE wire of the exit wand should be connected into the "#17" terminal.
The RED wire of the exit wand should be connected into the "#12" terminal.
The GREEN wire of the exit wand should be connected into the "#13" terminal.
The sensitivity adjustment board should be wired to the GREEN wire and the YELLOW wire of the wand. No
matter the polarity.
8. External Receiver (Optional)
The BROWN wire of the external receiver should be connected into the "1 6" terminal.
The BLACK wire of the external receiver should be connected into the "1 3" terminal.
The RED wire of the external receiver should be connected into the "1 2" terminal.
9. Wired Keypad (12VDC) (Optional)
The RED wire of the wired keypad should be connected into the "12" terminal.
The BLACK wire of the wired keypad should be connected into the "13" terminal.
The PURPLE wire of the wired keypad should be connected into the "16" terminal.
The BLUE wire of the wired keypad should be connected into the "15" terminal.

Setting of the Control Board

WARNING: Ensure the gate opener is Power Off when you make any adjustment of the gate opener.
Keep away from the gate during you set the gate opener system in case of the unexpected gate moving.
Carefully adjust the DIP switches to avoid the risk of machine damage and injury or death. Always ask
the help of professional technician /electrician if you have any question .
1. DIP Switches
33