Topens RK2600 Bedienungsanleitung Seite 38

The DIP switches are used to set the running time
of the motor in midway mode, auto close time of
the gate opener and fast change the open/close
direction which is determined by the position of
the gate opener installed.
DIP Switch #1–#2: Running time of the motor
in Midway Mode
This mode enables user to drive the vehicle through the gate quickly when the gate opens to certain width.
DIP Switch #1: ON – 4 Seconds OFF – 0
DIP Switch #2: ON – 2 Seconds OFF – 0
NOTE: The midway mode function would be disabled if both DIP switches are turned off. Factory default
setting is disabled. The midway mode could be activated by pressing button B of the remote control
when the gate is in the full closed position.
E.g. Running time of the operator in midway mode is 4+2=6 seconds.
DIP Switch #3–#4: Auto close time of the gate opener
DIP Switch #3: ON – 30 Seconds OFF – 0
DIP Switch #4: ON – 60 Seconds OFF – 0
NOTE: The auto close function would be disabled if both dip switches are turned to off (factory default
setting).
E.g. Auto close time of the gate operator is 30+60=90 seconds.
Important Note: When the auto close function is enabled, the photocell sensor is highly
recommended to be installed with the gate opener for safety.
DIP Switch #5: Left/Right open
ON – Left open (factory default setting).
OFF – Right open. Turn switch OFF to change the opening direction easy if necessary.
2. Potentiometers
The potentiometer A is to adjust the OPEN stall force of the gate opener. The Potentiometer B is used to adjust
34