Installation Of The Opener; Manual Operation - Topens Rk2600 Bedienungsanleitung

Installation of the Opener

Caution:
*Be sure that the opener is installed in a level
and paralleled position and is properly
secured. Improper installation could result in
property damage , severe injury, and/or death.
* Before starting installation, ensure that there
is no point of friction during the entire
movement of the gate and there is no danger
of derailment.
* Ensure that the safety side panels are
present.
Necessary Tools: The following tools may be
necessary to install the Gate opener. You will
need screwdrivers, an electric drill, wire cutters
and a wire stripper, a socket set, and possibly
access to a welder.
When install the opener, you should build a
concrete pad to support the base plate of opener
in order to maintain proper stability.
The installation proceeds are as follows:
1.Dig a hole for a concrete pad which should be approximately 47 x 40 x 35cm (18.5〞x 16〞x 14〞). It may
protrude 10 cm (4") above ground and 25 cm (10") in depth underground. Increase the pad height if necessary
to protect the system from flooding, heavy snow etc.
2. Prepare one or more conduits for the electrical cables before pour concrete. Remember that cable conduits
have to pass through the hole in the base plate.
3. Pour concrete and before it starts to harden, check that it is paralle l to the gate leaf and perfectly level.
4. The four anchor bolts must be set into the concrete when it is poured, make sure the position of anchor bolts
was placed according to the position of mounting holes on the base plate before concrete become harden.
5. Mount the base plate to the concrete Pad. It's only temporary installation. Further adjustment will be required
when install the rack.

Manual Operation

The opener should be put in the manual (emergency release) position before fitting the rack, installing the
opener and limit switch. The process is as follows:
1) Push the cover in arrow direction, now the key slot appears.
2) Insert release Key into the key slot and turn it in counter-clockwise 90° to disengage the clutch between the
gear shaft and power output. Now the opener is in the manual operation.
29