Other Settings - X4-Life Security DIY Bedienungsanleitung

DE EN
Disarm: By pressing this icon, you deactivate all transmitters except those set
to 24-hour mode. Press the open lock on the remote control, to deactivate the
alarm system. This will also switch off a resounding siren.
Home: If the system is set to "Home", all transmitters set to "Normal" or
"Delay" will signal alarm. For example, if you would like to activate the alarms
for your door and window sensors during the night but not the motion sensor,
set the sensors to "Normal" and the motion sensor to "Home" (see no. 4). Now
you can move freely around the house but the windows are still secured.

other settings

Settings (please confirm changes always with the check mark in the upper right
corner):
Hooting time of siren: Enter a number. This number sets the duration in
minutes for the siren to resound in case of an alarm.
Exit delay: Enter a number from 0 to 300. This number sets the time in seconds
that will pass until the unit is active after it is switched live.
Entry delay: Enter a number from 0 to 300. This number sets the time in
seconds that will pass until the siren will resound after the alarm is triggered.
Timing arm: Enter the time at which the unit will be activated automatically
each day, e. g. 10:45 PM.
Timing disarm: Enter the time at which the unit will be deactivated each day, e.
g. 06:30 AM.
remote control sound: If this icon is active (green), a beep will confirm use of
the remote control. If it is deactivated, no beep will sound.
Automatic activation oN/oFF: Here you can switch automatic activation/
deactivation on or off.
29
701552_Security-DIY_12x15-MAN.indd 29 10.01.2017 10:37:52