X4-Life Security DIY Bedienungsanleitung Seite 28

4. How to check/add/activate components
The app will show you all connected components if you click on the alarm
system. The standard devices are a motion sensor, a magnet sensor and a
remote control. If this is not the case or if you would like to connect additional
transmitters (up to 50 transmitters), please follow these steps:
» Tap settings in the upper right corner and select "add accessories". The hub
will now look for new transmitters within the signal range.
» Now activate the new transmitter by triggering it (switch on motion sensor
and trigger it by moving, by separating the magnet sensors or by pressing
the key on the remote control or the optionally purchased bell). Repeat these
steps for each component.
» Press the arrow at the top right corner of the app once to leave the current
screen, afterwards click onto the name of the device again. You have now
added the new transmitter.
» Each transmitter can be activated or deactivated by the on-off switch in the
app.
» Press and hold the name of a transmitter in the app to change detail settings
and switch modes.
» Each transmitter runs in 4 different modes:
a) Normal: In Normal mode, a transmitter signals alarm if the alarm system is
live or in Home mode.
b) Home: Home transmitters will not be triggered if the system is set to
"Home". Find more information under no. 5.
c) 24 hours: Transmitters set to this mode will always signal alarm, even if the
unit is deactivated.
d) Delay: Transmitters set to this mode will signal alarm after a certain delay.
Adjust the delay according to your requirements under "settings".
5. Using the app and advanced settings
Arm: Press activate alarm in the app to activate the unit. In this mode, all
transmitters will signal alarm if triggered. Alternatively, the alarm can be switched
on with the included remote control. To do this, press the closed lock key.
28
701552_Security-DIY_12x15-MAN.indd 28 10.01.2017 10:37:52