in the wall. There is danger to life if you drill into a power cord due to electric shock!
Use an appropriate electricity detector to find concealed power cords.
Always wear safety equipment and goggles.
Always wear ear protection if you work near the alarm signal.
Always mind your safety while using power tools (such as a drill).
Always follow the safety instructions of the instruction manuals.
Find a suitable spot to mount the motion sensor.
The perfect height for the installation is about 1.8 to 2.4 meters.
» Mount the wall holder with the included bolts/plugs to the desired spot.
» Insert the batteries and mind the correct polarity.
how to insert the batteries into the remote control
The remote control requires a 3 V battery (CR2032). Follow these steps to
replace the battery:
» Use a small screwdriver to remove the little rubber plug on the back.
» Remove the screw below the plug.
» Open the case with a flat slot screwdriver.
» Carefully lift the circuit board with a small slot screwdriver.
» Now insert the battery into the battery compartment with the + end pointing
away from the circuit board.
how to insert the batteries into the motion sensor
The motion sensor requires 2 AAA batteries.
» To open the case, move the cover of the battery compartment in the direction
of the arrow.
» Insert batteries. Mind the polarity.
» The negative pole must touch the spring.
» Move the cover of the battery compartment back.
Otherwise use a micro USB cord for power supply (not included). Plug the cord
into the micro USB port next to the On/Off-switch
701552_Security-DIY_12x15-MAN.indd 25
DE
EN
25
10.01.2017 10:37:51