Vacmaster SCB0501 03 Bedienungsanleitung Seite 10

1) Unwrap the hose and ensure a tool is attached securely.
2) Turn the quick release cord hooks to release the power cord (Fig. 9).
3）Plug the power cord into a power outlet.
WARNING: If any abnormality/failure occurs, stop using the product immediately and
disconnect the power plug.
4) Press the power button to turn the carpet cleaner on (Fig. 10).
5) For spills, first collect any excess liquid before using water/solution. Place the cleaning nozzle
towards the front of the spill and slowly pull backwards over the area.
6) To dispense cleaning solution, hold the tool about 2.5 cm over the area to be cleaned. Squeeze
the spray trigger to release a mix of water and cleaning solution (Fig. 11).
7) Release the trigger and use the brush on the nozzle to agitate cleaning area by scrubbing.
8) To lift away the stain, tilt the nozzle to make contact with surface and pull the tool backward
slowly to vacuum up excess dirty liquids. Repeat as necessary (Fig. 12).
NOTE: Ensure the nozzle is in contact with the surface, over or under tilting may result in poor pick up.
9) Once you have completed cleaning, press the power button and unplug the power cord.
3. Emptying The Dirty Water Tank
WARNING: Always unplug power cord from electrical outlet before performing any service
on carpet cleaner.
Empty the dirty water tank when the dirty liquid reaches the "Max Fill" line and there is a loss in
suction. During normal use, debris may accumulate in the dirty water tank. To keep the carpet
cleaner functioning properly, rinse the dirty water tank with clean water after each use and leave to
air dry before refitting.
1) Remove the dirty water tank from the side of the unit. A security latch ( ④ ) is positioned to
keep the dirty water tank in position to avoid unintentional release. The latch will automatically
release when the tank is pulled upwards (Fig. 13).
2) Remove the dirty water tank cover by releasing the dirty water tank cover tab (Fig. 14).
3) Empty the tank into a sink or toilet. Rinse the tank thoroughly with clean water. Allow the tank to
air dry before reinstalling (Fig. 15).
4) Insert the locking tabs into the slots of the dirty water tank first and then secure the dirty water
tank cover back into place until a click is heard (Fig. 16).
5）Reinstall the dirty water tank back onto the unit. The security latch will automatically secure the
dirty water tank in position. A click will be heard when correctly installed (Fig. 17).
WARNING: The motor noise changes to a higher pitch when the dirty water tank is full
or blocked. Stop the carpet cleaner immediately and empty the dirty water tank.
11
GB