Herunterladen Diese Seite drucken

IKA Tube Mill control Betriebsanleitung Seite 21

Vorschau ausblenden Andere Handbücher für Tube Mill control:

Werbung

Milling tube coupling broken:
The milling tube coupling may be broken when the
grinding material is too much or too hard.
Pull the broken coupling out from the drive unit:
 Fit the coupling extractor in clockwise direction. The
coupling puller is properly attached to the coupling af-
ter a "click".
 Turn the coupling extractor in counterclockwise direc-
tion. The broken coupling will be extracted out after
a "click".
The instrument is maintenance-free. It is only subject to
the natural wear and tear of components and their statisti-
cal failure rate.
Cleaning
Disconnect mains plug prior to
cleaning!
- Wear protective gloves when cleaning the devices.
- Do not place electrical appliances into the cleaning
agents for cleaning purposes.
- Do not allow moisture to get into the appliance when
cleaning.
- Please consult IKA
before using any cleaning or decon-
®
tamination methods, other than those recommended
here.
- The device must not be washed in a dishwasher.
- The protective hood is of polycarbonate and can be treat-
ed using commercially-available disinfectants. Avoid prod-
ucts that contain aldehydes, phenols, acetone or alcohol.
- It should be cleaned only by hand using a liquid disin-
fectant.
- The only cleaners or disinfectants that may be used are
those that:
- lie in the pH range 5 - 8,
- contain no corrosive alkalis, peroxides, chlorine
compounds, acids or brine.
- If rotator becomes contaminated with milled material,
clean it thoroughly with vacuum cleaner.
MT 40 milling tube
Using the coupling extractor
Maintenance and cleaning
Only clean IKA
cleaning agents. To remove use:
Dirt
Dyes
Building materials water containing detergent, Isopropanol
Cosmetics
Food
Fuels
Other materials
Spare parts order
When ordering spare parts, please give:
- Machine type
- Serial number, see type plate
- Item and designation of the spare part,
- software version.
Repair
Please send instrument for repair only after it has
been cleaned and is free from any materials which
may constitute a health hazard.
For this you should request the "Decontamination
Clearance Certificate" from IKA
printout of it from the IKA
Return the instrument in its original packaging. Storage
packaging is not sufficient. Also, please use suitable ship-
ping package material.
Accessories
• Labworldsoft
I
II
CLICK
appliances using these IKA
®
Cleaning agent
isopropyl alcohol
(do not use for the protective hood)
(do not use for the protective hood)
Water containing detergent, Isopropanol
(do not use for the protective hood)
Water containing detergent
Water containing detergent
Please consult IKA
see www.ika.com, spare parts diagram and spare
parts list
®
III
CLICK
approved
®
®
, or use the download
®
website www.ika.com.
®
21

Werbung

loading