INVENTOR LV6LI-12WiFiR Benutzerhandbuch Seite 11

4. Remove the air filter.
5. Clean the air filter by vacuuming the surface or
washing it in warm water with mild detergent.
A. If using a vacuum cleaner, the inlet side should
face the vacuum.
B. If using water, the inlet side should face down
and away from the water stream.
6. Rinse the filter with clean water and allow it to air-
dry. DO NOT let the filter dry in direct sunlight.
7. Reinstall the filter.
CAUTION
• Before changing the filter or cleaning, turn off
the unit and disconnect its power supply.
• When removing filter, do not touch metal parts
in the unit. The sharp metal edges can cut you.
Do not use water to clean the inside of the indoor
unit. This can destroy insulation and cause
electrical shock.
Do not expose filter to direct sunlight when
drying. This can shrink the filter.
• Any maintenance and cleaning of outdoor unit
should be performed by an authorized dealer
or a licensed service provider.
• Any unit repairs should be performed by an
authorized dealer or a licensed service provider.
Fig. 4.4
Fig. 4.5
Replace internal parts
1. Pull the left and right handles of the front panel ,
pull the panel outward, and open the panel.
2. Remove the 7 screws on the face frame.
3. Buckle up the snap indicated by the arrow and
remove the face frame.
4. Replace internal parts.
5. Install the face frame and panel parts.
◄ Page 11 ►