Product−Specific Safety Instructions - Lenze L-force Controls CAPS-PACK Montageanleitung

2 Safety instructions
Product−specific safety instructions
Commissioning
If required, you have to equip the system with additional monitoring and
ƒ
protective devices in accordance with the respective valid safety
regulations (e. g. law on technical equipment, regulations for the
prevention of accidents).
Maintenance and servicing
The components are maintenance−free if the required operating
ƒ
conditions are observed.
If the cooling air is polluted, the cooling surfaces may be contaminated or
ƒ
the air vents may be blocked. Under these operating conditions, the
cooling surfaces and air vents must be cleaned at regular intervals. Never
use sharp objects for this purpose!
After the system has been disconnected from the supply voltage, live
ƒ
components and power connections must not be touched immediately
because capacitors may be charged. Please observe the corresponding
notes on the device.
Disposal
Recycle metals and plastic materials. Ensure professional disposal of
ƒ
assembled PCBs.
2.2 Product−specific safety instructions
The device must not be charged by means of external chargers.
ƒ
The device must not be opened.
ƒ
In case of an error, unplug the device immediately. Then return the device
ƒ
to the manufacturer. The address can be found at the back of this
documentation. Please use the original packing to return the device!
28
l
LDCDS−2701 DE/EN 2.0