Armytek PRIME C1 PRO Benutzeranleitung Seite 5

To clean the threads do the following:
1. Unscrew the tailcap and remove the sealing rings carefully with a
toothpick (do not use sharp metal objects as they can damage the
rings).
2. Wipe the sealing rings thoroughly with a soft cloth (or tissue). Do not
use solvents. If the sealing ring is worn out or damaged, replace it
with a new one.
3. Clean the metal threads with a brush using ethanol. Be careful not to
allow the applied liquid inside the flashlight, as it can cause malfunc-
tioning of the flashlight.
After cleaning, grease the threads and the sealing rings that have
been installed in place with polyalphaolefin-based silica grease, e.g.
Nyogel 760G. The application of other types of grease is unacceptable.
In case of active operation and exploitation in dusty environments, it is
recommended to clean and grease the parts as often as the necessity
arises.
WE DO NOT RECOMMEND leaving power supplies (especially
non-rechargeable) inside the flashlight for a long storage period, as
they can leak for various reasons and damage the inner parts of the
flashlight. If you want to keep your flashlight in a stand-by state with
batteries in, previously install new and high-quality batteries, store
the flashlight in acceptable for batteries operational temperature and
revise the batteries' state at least once a month. If you have noticed any
signs of defects, withdraw the batteries from the flashlight and dispose
of them.
Warranty and Service
Armytek provides free warranty repairs for 10 years (excluding
batteries, chargers, mounts, holders, switches and connectors, which
have 2-year warranty) from the date of purchase if there is a document
confirming the purchase.
The warranty does not apply to magnets, silicone covers of connectors
and buttons, silicone installation rings and holders, clips, silicone grips,
holsters, lanyards, O-rings and pads, Velcro tapes. The warranty also
does not extend to damage during:
1. Improper usage.
2. Attempts to modify or repair the flashlight by nonqualified
specialists.
3. Application in chlorinated, contaminated liquids or sea water.
4. Immersion into liquids in case of broken leakproofness.
5. Exposure to high temperatures and chemicals, including the liquids
from defected batteries.
6. Usage of low-quality batteries.
REV_00-0000 PRIME C1 PRO USER MANUAL ENG 5