Function „Schedule Recording; Function „Sd Overwrite - Renkforce 808576 Bedienungsanleitung

• Confirm the setting with „
• If required, push the button „MENU" repeatedly to return to the respective previous menu or to leave the
OSD menu.
Function „Schedule recording"
The screen/DVR can record automatically between two settable times, e.g. between 8 AM and 5 PM. In
the function „Schedule recording", the start and end time can be set and the automatic recording can be
switched on.
Proceed as follows:
• Use the buttons „4" and „6" to pick the function „Schedule recording" and then push „
• Use the buttons „4" and „6" to select the desired input position. It is marked red.
Use the buttons „8" and „2" to set the hours or minutes.
„Start Time" = Starting time for recording (hours: minutes)
„End Time" = End time for recording (hours: minutes)
• To switch the automatic recording function on or off, select „ON" or „OFF" and push the button „
„ON" = switch on automatic recording function
„OFF" = switch off automatic recording function
• If required, push the button „MENU" repeatedly to return to the respective previous menu or to leave the
OSD menu.
Function „SD overwrite"
For a full memory card, no new recording can be performed and the memory card must be replaced with a
new, empty one (or the data on the memory card must be recopied to a computer).
If desired, an overwriting function can be activated, however. The respective oldest recording is then
replaced by the new one.
Proceed as follows:
• Use the buttons „4" and „6" to pick the function „SD overwrite" and then push „
• Use the buttons „4" and „6" to switch between „YES" (overwriting function on) and „NO" (overwriting
function off).
• Confirm the selection with „
• If required, push the button „MENU" repeatedly to return to the respective previous menu or to leave the
OSD menu.
58
".
".
".
".
".