Kidwell BLISSY BASIC Benutzerhandbuch Seite 8

Dear Customer!
Thank you for choosing Kidwell,
Our highest priority is the safety of your child and the creation of beautiful memories.
We hope you will enjoy our product, in case of any questions please contact us at:
bok@kidwell.eu
Please read through the entire manual carefully and follow all instructions. Before you
start using our product make sure that all of the features are working as intended and
are secure (fasteners, nuts, bolts, screws, etc.). The assembly must be performed by an
adult. Failure to comply with the instructions and safety warnings could result in serious
injuries.
NOTE: Remove and discard all packaging elements included with the product so they
are out of the reach of the child (e.g. cardboard pieces, plastic film/bags, etc.). Risk of
injury, e.g. choking hazard
NOTE: This product is for DIY assembly.
WARNING:
• To prevent injury from falling, do not use the cot any longer if the baby begins to
climb and can leave the cot.
• The lowest base height setting is the safest one. It is recommended to start using
the cot with the lowest height setting of the base when the baby can sit unassisted.
• Never leave anything in the cot on which the baby could support its legs or cause a
hazard of choking or strangulation, e.g. cords, ropes, or window curtain ends. Do not
place the baby cot near any objects which could provide support for the baby's legs.
• Do not use the cot if any part is damaged, torn, or missing. Always use the
manufacturer-recommended parts only. Never replace the genuine parts with any
spare parts not recommended by the manufacturer.
• Mind open fire and other sources of strong heat, like electric or gas radiant heaters
placed near the baby cot.
• The baby cot is ready for use only with its locks engaged. Before use, carefully
inspect to verify that all locks are fully engaged.
• Before leaving the baby in the cot unattended, make sure that the moving cot side
is closed.
• The maximum mattress thickness must not be more than 8 cm.
• The mattress for the baby cot should measure 120x60 cm. The mattress thickness
and height above the floor must keep the gap between the sides and top edges 30
mm or less.
• All assembly parts and hardware must be properly tightened during the assembly
process and regularly inspected for tightness, and retightened as required afterwards.
• The mattress thickness should keep the height inside of the cot (measured from the
mattress top to the top edge of the cot frame) 500 mm or higher with the cot bottom
8
READ AND KEEP THIS MANUAL FOR REFERENCE.
CAUTION!