Maintenance And Cleaning; Associated Standards And Regulations; Accessories - IKA IKAMAG RCT basic Betriebsanleitung

torque does not exceed its maximum.
Please note that mains fluctuations within the permissible tole-
rance also effect minor fluctuations of the speed.

Maintenance and Cleaning

The IKAMAG RCT basic is maintenace-free. It is subject only to
the natural wear and tear of components and their statistical failu-
re rate.
When ordering spare parts, please give the manufacturing
number shown on the type plate, the machine type and the
name of the spare part.
Please send in equipment for repair only after it has been cleaned
and is free from any materials which may constitute a health
hazard. Use only cleansing agents which have been approved by
IKA to clean IKA devices. To remove use:
Dyes
Construction materials water containing tenside / isopropyl alcohol
Cosmetics
Foodstuffs
Fuels
For materials which are not listed, please request information from
IKA. Wear the proper protective gloves during cleaning of the devi-
ces.
Electrical devices may not be placed in the cleansing agent for the
purpose of cleaning.
Before using another than the recommended method for cleaning
or decontamination, the user must ascertain with the manufactu-
rer that this method does not destroy the instrument.
RCT B sc 0305
isopropyl alcohol
water containing tenside / isopropyl alcohol
water containing tenside
water containing tenside

Associated standards and regulations

Construction in accordance with the foolwing safety standards
EN 61010-1(IEC/CEI 61010-1)
UL 3101-1
Construction in accordance with the foolwing EMC standards
EN 61 326-1
Associated EU guidlines
EMC-guidlines: 89/336/EG; 92/31/EG
Machine guidelines: 73/23/EG

Accessories

RS 1 set of stirring bars H16V support rod
RSE PTFE stirring bar remover H 43 contact safety devive
R 380 stand support H 15 bath top
R 360 holding fork ETS-D IKATRON
H 36 holding rod H 44 cross sleeve
Recommended IKA-stirres
TRIKA-stirrers PTFE, triangular
lengths 25, 42, 55, und 80 mm
IKAFLON-stirrers PTFE
dia 6mm lengths 10 and 15 mm
dia 7mm lengths 20, 25, 30, 40, 50 and 60 mm
dia 10mm lengths 70 and 80 mm
CAN/CSA C22.2 (1010-1)
13