Before Starting Operation; Setting Up Power Supply - Bresser MyTime Meteotime LCD Schnellstartanleitung

7 Wind speed (forecast for the relevant day)
9 precipitation probability (forecast for the
relevant day)
11 Graphical presentation for weather condi-
tions
13 Weekday
15 Remote sensor symbol (when measure-
ment values are displayed)
17 Battery level (remote sensor)
19 City to the nearest Meteotime measure-
ment station
21 Alarm W (default setting is OFF)
23 Alarm P (default setting is OFF)
25 NIGHT symbol (weather conditions during
the night)
27 Bad weather warning: Flood
29 Warning symbol
31 Alarm symbol W (weekdays)
33 Alarm symbol S (one-time)
35 Pre-alarm interval (15, 30, 45, 60 or 90
minutes before the pre-set alarm)

7 Before starting operation

NOTICE
Avoid connectivity disruptions!
To avoid connectivity disruptions between the devices, consider the following points before starting
operation.
1. Place base station (receiver) and remote sensor (sender) together as close as possible.
2. Set up power supply for the base station and wait until the indoor temperature is displayed.
3. Set up power supply for the remote sensor.
4. Position the base station and the remote sensor within the effective transmission range.
When changing batteries always change batteries in the main unit as well as all remote units and re-
place them in the correct order, so the remote connection can be re-established. If either of the
devices is mains-powered, the power supply must be disconnected for a short moment also for this
device when exchanging the batteries. If batteries are exchanged in only one of the devices (i.e. the
remote sensor) the signal can't be received or can't be received correctly.
Note, that the effective range is vastly affected by building materials and position of the main and re-
mote units. Due to external influences (various RC devices and other sources of interference), the
maximum distance can be greatly reduced. In such cases we suggest to position the main unit and the
remote sensor at other places. Sometimes all it takes is a relocation of one of these components of a
few inches! Though the remote unit is weather proof, it should be placed away from direct sunlight,
rain or snow.

8 Setting up power supply

Base station
1. Remove the battery compartment cover.
14 / 20
8 Temperature (forecast for the relevant
day)
10 Wind direction (forecast for the relevant
day)
12 Meteotime symbol (weather data is
streamed)
14 Calendar week
16 Indoor symbol (when measurement values
are displayed)
18 AM/PM information in 12-hour time mode
20 Timer (countdown until next alarm)
22 Alarm S (default setting is OFF)
24 DAY symbol (weather conditions during
the day)
26 Bad weather warning: Heavy rain
28 Bad weather warning: Dense fog
30 Warning symbol, flashing
32 Alarm time setting (hours, minutes)
34 Alarm symbol PRE-AL (Frost warning)