Cleaning And Maintenance - tepro Pasadena 1030 Bedienungsanleitung

– Do not wear any clothing with wide
sleeves.
– Only use dry igniters or special BBQ
lighter fluid in compliance with EN
1860-3 to start the BBQ.
1. Remove the BBQ grates (2).
2. Place 3-4 solid firelighters in the mid-
dle of the fire tray (6). Pay attention to
the manufacturer's instructions on the
packaging. Light the firelighters with
a match.
3. Layer a maximum of 2 kg of char-
coal around the firelighters.
4. Prior to first use, the BBQ must be
pre-fired for a minimum 30 minutes.
See section Before grilling .
5. As soon as the charcoal is glowing,
spread it evenly over the fire tray (6).
To do this, use a suitable fireproof
tool with a long, fireproof handle.
6. Hang the BBQ grates (2) at the
desired height on the bracket on the
left and right windshield.
7. Only place the BBQ meat on the
grate when the charcoal is covered
with a bright layer of ash.
P170002_TEPRO_1030_Pasadena_DE_GB.indb 17

Cleaning and maintenance

Your grill is made of high-quality materi-
als.
Please note: Stainless steel changes co-
lour at high temperatures! This is not a de-
fect, but rather a sign of quality!
To clean and maintain the surfaces,
please heed the following instructions:
Danger Risk of burning!
Let the grill cool down complete-
ly before cleaning.
– Empty the ashes once the fuel has
burned down completely and is out.
Danger Health hazard!
Do not use any paint solvents or
thinners to remove stains. Such
liquids are hazardous to health
and may not come into contact
with food.
Attention Risk of damage!
Do not use any strong or abrasive
solvents or scouring pads as
such products attack the grill's
surfaces and leave permanent
markings.
• Let the fuel burn out completely after
grilling. This eases the cleaning effort
by burning away excess fat and BBQ
residues.
• Remove the BBQ grates and clean
them thoroughly in soapy water. Rinse
the BBQ grates with clear water and
thoroughly dry them.
• Empty out the cold ash. It is very im-
portant you remove the ash before
moisture comes into contact with
the cold ash. Ash contains salt and
affects the inside of the fire tray
when damp. Therefore the fire tray
can be damaged by rust over the
years.
t
17
16/1/17 10:43 AM