Factory Configuration - Legrand In One Pro 21 7756 18 Bedienungsanleitung

Factory configuration

The first time it is switched on, pressing keys 1, 2, 3 or 4 does not control any product in the "In One by Legrand"
installation.
Operation
Scenario control :
- Using keys 1, 2, 3 or 4 it can simultaneously control sets of products (actors) that have been associated with it during
the learn phase (1) . It is then the leader of the scenario
It is always the central control point (leader) of a scenario. It can control lighting or opening points as required.
It has an interface for the infrared signals used to control its scenarios and/or other products in the installation.
(1) Learn phase : Operation to associate products so that they can be controlled simultaneously from a central point.
This association is carried out by applying the learn scenario procedure on page 4.
(2) Scenario : Corresponds to the set of products (actors) that are associated with a command key.
Key
The indicator lamp The indicator lamp
goes off blinks slowly
Learn scenario
Step 1 : Start the learn phase (on the LEADER)
Press LEARN
Step 2 : Add an actor to the scenario (on the ACTOR)
Press LEARN
To add a number of products to the scenario, repeat operations
Step 3 : Record the scenario (on the LEADER)
Press LEARN
(2) .
3
The indicator lamp
blinks quickly
Press the command key that is to
control the scenario
Press the command key that is to be
associated with the leader
and for each actor.
The indicator lamps of all the products go off.
The scenario is recorded.
4
The indicator lamp
flashes