A-rival PNV Bedienungsanleitung Seite 40

40
4.6.1 USB Setting
Connect the GPS navigator to PC via the MINI USB port to transmit data, or back up data
from the navigator data to PC.
The GPS navigator provides MASS STORAGE and MS STORAGE modes. Select one in
the settings
NOTE ! For normal navigation this setting MUST be set to MS Active Sync ! In other
case the device will stop operating when connected to a cherger and change into
data-transmission-mode.
1. Have the GPS navigator in operation status and the SD card plugged in the slot;
2. Tap the icon in the System Info interface to enter the following interface:
Select MASS STORAGE and tap to save the selection.
3. Connect the MINI USB terminal of the USB cord to the MINI USB port of the GPS
navigator and the standard USB terminal to the USB Host port of PC. Then, the navigator
stops the current program and switch to the following interface.
4. After communication, unplug the MINI USB cable.