Power Supply & Charging; Power Supply - A-rival PNV Bedienungsanleitung

29
1.2 Power Supply & Charging
Charge the GPS navigator fully with the charger before first use.

1.2.1 Power Supply

The a-rival PNV-43 navigation system can be powered by the built-in battery or external
power supply.
When the GPS navigator is unconnected to the charger, it is powered by the Li-polymer
battery. The battery capacity icon in the system main interface shows current residual
battery capacity.
When the GPS navigator is connected to the charger, it is powered by external power and
the battery is charged.
[Attention] The GPS navigator adopts non-removable Li-polymer battery. To avoid battery
rupture, explosion, release of hazardous substance or burn, do not unpack, pierce, strike
on or discard the battery in fire or water.
1.2.2 Charge by Charger
The GPS navigator must be charged with the charger before first use.
Plug the USB terminal of the charger into the USB port on the left side of the GPS
navigator and the other to the power socket to supply power and charge the GPS
navigator.
[Note]: The charging indicator light is red during charging. Do not unplug the charge until
the battery is fully charged and the indicator light turns green. Please charge the GPS
navigator when the battery is low or used up in succeeding use.
1.2.3 Charge by Car Charger
Plug one terminal of the car charger into the USB port on the left side of the GPS
navigator and the other to the charging port to supply power and charge the GPS
navigator.
[Note]: Plug in the car charger after the automobile is started to avoid damage due to
current surge.