Basic Use; Power Off - A-rival PNV Bedienungsanleitung

30

1.3 Basic Use

1.3.1 Power on/off
2.3.1.1 Power on
Press the power key on the top side of the GPS navigator for at least two seconds to
power it on.
[Note]: Great humidity fluctuation may lead to short circuit of the GPS navigator. Power on
the navigator after it has accommodated to new environment.

2.3.1.2. Power off

Press the power key and let go after two seconds to power off the GPS navigator. The
following interface will be prompted. If no operation on the interface in 20 seconds, the
system will be powered off automatically. If is selected, the navigator will
automatically resume the state before entering sleep mode when powered on again.
1.3.2 Restart the System
When the system does not response, press the reset key on the right side of the GPS
navigator to restart the system.
[Relevant Information] The following situations might lead to no response of the system.
1. Delay or stagnancy in interface switching;
2. Failure of function activation with overlong execution;
3. Failure to power on/off the GPS navigator by pressing the power key
[Note]: Restarting the system by pressing the reset key will result in loss of unsaved data.
Please backup your data regularly.
In case that your navigation-system contains a built-in TMC-receiver for reception
of traffic-information, it's antenna is integrated into the car-charger-cable. For
correct reception of traffic-information the car-charger needs to be connected to
the USB-port of the navigation-system!