Elma Instruments Elma 3036 Bedienungsanleitung Seite 49

All manuals and user guides at all-guides.com
Elma 3036 + 3038 + BM126 side 49
HOLD
The hold feature freezes the display for later view. Press the HOLD button momentarily to
activate and to exit the hold feature in the following function(s):
BM111 & BM112: All functions
BM125 & BM126: Upper display ACA function
MAX
The max feature compares and displays the measured maximum value as fast as 30ms with
auto-ranging capability. Press the MAX button for 1 second or more to activate and to exit
the max feature in the following function(s):
BM111 & BM112: DCV, ACV & ACA functions
BM125 & BM126: Upper display ACA function
Relative zero mode (Single Display models only)
Relative zero mode allows the user to offset the meter consecutive measurements with the
displaying reading as the reference value. The display will now show readings relative to the
stored reference value. That is, display = reading - stored value. Press the button
momentarily to activate and to exit relative zero mode.
Auto-ranging
Where there is more than one measuring range under a selected meter function, the LCD
annunciator "a" turns on. The meter will automatically switch to the best resolution range when
making measurements. No manual ranging selection is required.
Auto Power Off (APO)
When the meter is on, the Auto Power Off (APO) feature will switch the meter into a sleep mode
automatically to extend battery life after approximately 30 minutes of no slide-switch nor push
button operations. To wake up the meter from APO, press the buttons momentarily or set the
slide-switch to the OFF position and then slide back on again. Always set the slide-switch to the
OFF position manually when the meter is not in use.