Elma Instruments Elma 3036 Bedienungsanleitung Seite 42

Warning
To reduce the risk of fire or electric shock, do not expose this product to rain or moisture. The
meter is intended only for indoor use.
To avoid electrical shock hazard, observe the proper safety precautions when working with
voltages above 60 VDC or 30 VAC rms. These voltage levels pose a potential shock hazard to
the user.
Keep your hands/fingers behind the hand/finger barriers (of the meter and the test leads) that
indicate the limits of safe access of the hand-held part during measurement. Inspect test leads,
connectors, and probes for damaged insulation or exposed metal before using the instrument. If
any defects are found, replace them immediately.
This Clamp-on meter is designed to apply around or remove from uninsulated hazardous live
conductors. But still, individual protective equipment must be used if hazardous live parts in the
installation where measurement is to be carried out could be accessible.
CAUTION
Disconnect the test leads from the test points before changing meter functions.
INTERNATIONAL ELECTRICAL SYMBOLS
!
Caution ! Refer to the explanation in this Manual
Caution ! Risk of electric shock
Earth (Ground)
Double Insulation or Reinforced insulation
Fuse
AC--Alternating Current
DC--Direct Current
Application around and removal from hazardous live conductors is permitted
CENELEC Directives
The instruments conform to CENELEC Low-voltage directive 73/23/EEC and Electromagnetic
compatibility directive 89/336/EEC
All manuals and user guides at all-guides.com
Elma 3036 + 3038 + BM126 side 42