Adjusting Your Rubber Strap - Doxa SUB 200 T.GRAPH Bedienungsanleitung

ADJUSTING YOUR RUBBER STRAP

1.
Detach the clasp from the strap
by removing the spring bar at the end
of each half of the strap.
Example 1 : Even overlap with 6 holes.
6 divided by 2 equals 3, plus 1 hole at
each end, equals 5. Trim both halves
at the 5 hole.
th
16
2.
For the proper strap length, overlap
both halves around your wrist. Count the
number of holes and divide by 2. Add
1 hole at each end for the clasp. You now
have the correct length to trim to.
Example 2 : Odd overlap with 5 holes.
5 divided by 2 equals 2.5, plus 1 hole at
each end, equals 4.5. Trim at the 5 hole
th
on the 12 o'clock half, and at the 4 hole
th
on the 6 o'clock half.
3. Reinsert the spring bars at the end
of each strap half.
4. Re-fasten both strap halves to the
clasp, waved side facing inward. Make
sure the spring bars are securely nested
in the clasp.
17