Intenso XS5000 Bedienungsanleitung Seite 14

b) Charging devices with the Powerbank
This Powerbank has a USB-A connection (USB-A Out) and a USB-C connection (USB-C In/Out) to charge
connected devices.
With the Powerbank you can charge two devices at the same time, for example a tablet to the USB-A con-
nection and a smartphone to the USB-C connection.
Connect the supplied USB-A to cable USB-C with the USB-A connection (USB-A Out) of the Powerbank and
the opposite end of the USB cable with the USB-C connection of the device to be charged. If the charging
procedure does not start automatically, press the function key to manually start the charging procedure.
Of course, you can also use your own USB charging cable to connect the Powerbank to your device. How-
ever, please consider that the devices can only be charged by the USB-A connection (USB-A Out) and the
USB-C connection (USB-C In/Out) of the Powerbank.
If a device is charged with the Powerbank and the capacity of the Powerbank is almost exhausted, this is
signalled by blinking of the last status LED. Please re-charge the Powerbank.
Please note that while charging a device with a Powerbank, about 30% of the total capacity is used up just
through the charging process. This is due, for example, through the loss of power from circuit warmth and
voltage conversion.
The Powerbank has to be used regularly for optimum performance. If this is not the case, charge the Power-
bank fully at least every three months.
Make sure that the warmth created through the charging process can be emitted from the device (ideally
place the Powerbank on a firm and heat-resistant base while in use).
SERVICE / DISTRIBUTOR
INTENSO INTERNATIONAL GMBH I Kopernikusstraße 12-14 I D-49377 Vechta
Email (technical support):
Email (RMA number):
Internet:
Telephone (technical support):
support@intenso-international.de
rma@intenso-international.de
www.intenso.eu
+49 (0) 4441 – 999 111 (Mon. – Thur. 09:00 – 16:30;
Fri. 09:00 – 14:00)
EN - Page 5 of 6