EINHELL TE-AC 18/75 Li OF Originalbetriebsanleitung Seite 20

10. Possible causes of failure
Problem
The compressor
does not start.
The compressor
starts but there is no
pressure.
The compressor
starts, pressure is
shown on the pres-
sure gauge, but the
tools do not start.
Anl_TE_AC_18_75_Li_OF_SPK13.indb 20 Anl_TE_AC_18_75_Li_OF_SPK13.indb 20
GB
Cause
1. No power supply
2. Outside temperature is too low.
3. Motor is overheated.
1. The non-return valve leaks.
2. The seals are damaged.
3. The drainage cock for condensati-
on water has a leak.
1. The hose connections have a leak.
2. A quick-lock coupling has a leak.
3. Insuffi cient pressure set on the
pressure regulator.
- 20 -
Solution
1. Check the rechargeable batteries
2. Never operate with an outside tem-
perature of below +5° C.
3. Allow the motor to cool down. If
necessary, remedy the cause of the
overheating.
1. Have a service center replace the
non-return valve.
2. Check the seals and have any da-
maged seals replaced by a service
center.
3. Check the drainage cock and repla-
ce if necessary.
1. Check the compressed air hose
and tools and replace if necessary.
2. Check the quick-lock coupling and
replace if necessary.
3. Increase the set pressure with the
pressure regulator.
11.10.2023 14:47:41 11.10.2023 14:47:41