Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fault
The burner immediately
switches off after
releasing the control
knob.
Technical Assistance Service
Warranty conditions
Used appliances and packaging
Environmentally-friendly waste
management
Possible cause
The control knob was not held down for
long enough.
The grooves on the burner are dirty.
When contacting our Technical Assistance Service,
please provide the product number (E-No.) and
production number (FD) of the appliance. This
information is given on the specifications plate located on
the lower section of the hob and on the label in the user
manual.
The applicable warranty conditions are those set out by
the company's representative office in the country of
purchase. Detailed information is available from retail
outlets. Proof of purchase must be presented to obtain
the benefits of the warranty.
We reserve the right to introduce changes.
If the ) symbol is shown on the specifications plate, bear
in mind the following instructions.
Unpack the appliance and dispose of the packaging by
environmentally-friendly means.
This appliance complies with European directive
2002/96/CE on electrical and electronic equipment
identified as WEEE (waste electrical and electronic
equipment).
Solution
Once the burner is on, hold the control knob
down a few seconds longer.
Clean the grooves on the burner.
15
Werbung
