EKSA Telecom H16 Benutzerhandbuch Seite 6

Bluetooth Pairing
Connection
2. If no connection is successful after power on, it will automatically enter the
pairing state.
(3) When the headset is disconnected, it will automatically enter the pairing state.
(4) Turn on the Bluetooth of the device, search for the Bluetooth headset, and
then select "EKSA-H16" for pairing connection. After the connection is
successful, the headset prompts "Connected", and the blue light flashes once
every 10s. The device displays that the Bluetooth headset is connected.
EKSA-H16
Note:
1. If you need to connect a new device, you need to disconnect the Bluetooth connection from
the connected device first, and the headset will automatically enter the pairing state, then use the
new device to search for Bluetooth and complete the connection with the headset.
2. Each time the headset is turned on, it will automatically search for and connect to the nearest
connected device.
3. When the phone is turned on (except for the call), press and hold the volume up key and
volume down key for 5 seconds at the same time, and the red and blue lights flash once at the
same time to clear all pairing information in the headset. After the pairing record is cleared, the
previous device cannot be connected after the phone is turned on again, and you need to pair
and connect again.
(1) When the phone is turned
off, long press the "power
button" for about 5 seconds to
turn on the phone. The blue
5"
light and red light flash
alternately, and the headset
enters the pairing state.
4