AXXAIR 122 Originalbetriebsanleitung Seite 37

INNOVATIVE ORBITAL SOLUTIONS
5 Machine's fixing
AXXAIR's machine is designed to be used in a workshop or in a construction site. It must be placed on a
flat and stabilized surface. (workbench, AXXAIR support bench, AXXAIR support legs, ...etc)
The machine must be bolted on its support. To this end, there are four holes on the machine's base (two
taped holes M12 sized and two through-holes for M12 sized screws).
If the machine is placed and bolted on a workbench, make sure that the whole is stabilized (machine +
workbench + tube to process), as well as the supported load of the workbench.
Indicative table to conceptualize tubes weight
Material
Steel/SS
Steel/SS
Steel/SS
Steel/SS
Danger caused by handling heavy loads
Various injuries or material damage
Fixing AXXAIR's support bench to the ground is REQUIRED
Fixing AXXAIR's support legs to the ground is REQUIRED
DANGER
Personal protective equipment required
Join experience
Through-holes for M12 sized screw
Tubes weight
External Ø
114.3 mm
168.3 mm
219.1 mm
323.9 mm
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
Taped holes M12 sized
Thickness Weight / m
15 mm 37 kg
15 mm 57 kg
15 mm 76 kg
15 mm 115 kg
330B Route de Portes Les Valence - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - commerce@axxair.com - www.axxair.com
ENGLISH
-37-