Klarstein AMAZONIA 8 Bedienungsanleitung Seite 47

EN
Drain excess water from the hoses
If the washbasin is 1000 mm higher than the floor, the drain hose cannot be placed
directly in the washbasin. It is necessary to drain the excess water into a bowl or a
suitable container that is lower than the sink.
Water outlet
Connect the drain hose. The hose must be connected correctly to avoid leaks. Make sure
the hose is not kinked.
Extension hose
If you need a hose extension, you should choose a hose that is similar to the drain hose.
The hose extension must not be longer than 4 metres, otherwise the performance of the
dishwasher could be affected.
Connection to the siphon
The drain pipe must not be higher than 100 cm from the bottom of the dishwasher. The
water hose should be fixed.
Positioning the unit
Place the device in the desired location. The back of the appliance should be against
a wall and the sides of the dishwasher should be against the cupboard walls or walls.
The dishwasher is equipped with water inlet and outlet hoses that can be positioned on
either the left or right side of the appliance to simplify installation.
47