Nedo ECO 600 H Bedienungsanleitung Seite 11

Structure
ECO 600 H control panel
ON/OFF button
1
Switches the unit on and off.
"Equipment On" LED display
2
Lights up red if the unit is switched on.
Initial Startup
ECO 600 H
When starting the ECO 600 H rotating laser up for the first time, charge the integrated set of
rechargeable batteries (4.8 V) using the charger supplied. The charger socket is located below
the handle, behind a rubber cap. The set of batteries is fully charged when the green LED on
the charger lights up.
Important!
Only use the charger supplied.
Receiver
Insert the battery supplied (type 9V) in the receiver.
Ensure pole direction is correct!
Starting up the unit
When using on site, set up the ECO 600 H horizontally.
Operating Instructions ECO 600 H Rotating Laser
1
2
EN
11