Domo DO7352H Gebrauchsanleitung Seite 37

ASSEMBLY
Remove all parts from the packaging. Remove all packaging materials and any
promotional stickers.
1. Place the tube on the base. Note the groove in the tube so that it corresponds to the
tongue in the base.
2. Use the supplied screw and nut to screw the tube into place on the underside of the
base.
3. Place the heating component on top of the tube. Note the groove in the tube so that
it corresponds to the tongue in the heating component. Press the buckle and push
the heater into the tube until it clicks into place.
REMOTE CONTROL
Before using the appliance with the remote control, a coin cell battery (CR2032) must be placed in the
remote control. Follow the instructions below.
USE
Before you use the appliance: plug in the appliance and turn on the on/off switch at the back of the device.
The unit emits an audible signal to indicate that the device is in standby mode. You can set the appliance
using the control panel, but also using the remote control. You can make the settings in the same way.
The display will show you the selected settings. Each time a button is pressed, the device emits an audible
signal to indicate that the user is making a setting or adjustment.
ON/OFF SWITCH
Push the on/off switch to turn on or off the appliance. 35°C and the symbol
the device is switched on. This is the default setting. When you switch off the unit, the fan still works for a
few seconds before it stops completely.
Note: when the device is switched off via this button, the device goes into standby mode. This means it is
not completely disabled. You can only switch the device off completely via the on/off switch on the back of
the device.
www.domo-elektro.be
2
2
3
1
3
4
appear on the display when
3
1
2
37
DO7352H