Siemens Scio Referenzhandbuch Seite 14

Menu Item Description
Auto Zero Delay Delays automatic zeroing for 5 minutes for
uninterrupted monitoring.
Note: Gas sensors in the Scio module are
automatically zeroed and calibrated against
room air. During zeroing, the monitor tempo-
rarily blanks Scio parameter values. One
minute before automatic zeroing, the monitor
sounds an attention tone and displays the
message Auto zero in 1 minute.
etCO2* Alarms Accesses etCO
User's Guide Chapter 5)
O /N O Monitoring
2 2
The O
Scio module. The O
centration values for the following parameters:
Inspired O
inspiration phase
Expired O
the expiration phase
N
2
The appearance of the O
whether or not the N
Typical O
Parameter Box
Page 10
The etCO
2
WARNING: Delaying the auto zero
may inpact the accuracy of the
device.
* alarms in Alarm Limits table (see SC 7000/8000/9000XL
2
waveform indicates O
2
parameter box can display the current con-
2
( iO ) — The level of O
2 2
( ) — The level of O
etO
2 2
O — The concentration of N
2
O display is turned on in the O
2
/N O parameter box displays are shown below.
2 2
Description
ScioModule:
N O display turned off.
2
This module calculates both iO
Scio Module:
N O display turned on.
2
This module calculates both iO
Scio MODULE D011100
* Setup Menu
Settings
N/A
concentrations calculated by the
2
in the airway during the
2
in the airway during
2
O in the patient's airway
2
parameter box varies depending on
and etO
2
and etO
2
menu.
2
values.
2
values.
2
SC 7/8/9XL VF2.x