Duravit SensoWash Serie Montageanleitung Seite 7

Electrical installation
Power supply
Max. rated power
Circuit breaker
RCCB
Protection type
Protection class
Position of electrical / water connection
IG 1/2"
60 60
Pre-installation
> Lay a permanent power supply line:
Please observe the position of the electrical connec-
tion
Leave at least 800 mm of feed cable exposed
> Install circuit breaker
Connect a separate upstream circuit breaker
Connect an upstream residual current device (RCCB)
separating all poles
18
Connecting the cable (Diagram 18)
> Please observe the L, N and PE conductors.
20
Installing junction box (Diagram 20)
> Fix the junction box in the floor-standing toilet in
the designated place.
220 – 240 V ~ 50/60 Hz
1.65 kW
I = 16 A
N
I = 30 mA
N
IP X4
1
Water installation
Cold water DN 15 (1/2")
Water pressure 0.07 - 0.75 MPa
(0.7 - 7.5 bar)
Water hardness max. 2,4 mmol/l
NOTE!
> Install a water water softener with water
hardness ≥ 2.4 mmol/l (≥ 14° dH and/or
24° fH).
Pre-installation
> Install the water connection and water outlet in the
specified areas.
DANGER!
Health risk and potential product damage.
> Supply the Shower WC with cold drinking water from the
main water system.
> Do not connect any waste water, grey water, industrial
water, sea water or other untreated or semi-treated
water.
7
Connecting the water (Diagram 7)
NOTE! Avoiding any malfunctions!
> Only use the water supply hoses provided.
9
Connecting the water (Diagram 9)
NOTE! Avoiding any malfunctions!
> Only use the water supply hoses provided.
7
SensoWash_MAL_SWC_54025/14.05.4