VESTEL EVC02-AC22 Serie Benutzerhandbuch Seite 5

one time beep sound and just after that tap the user
card that you want to register. EVC plays two times
short beep sound for successful registering of user
card. Apply this procedure for the all user cards that
you want to register. Your EVC have a memory for
registering maximum 20 user cards. You can also
use your master card for removing the registered
RFID user cards from the EVC. For removing a user
card from the local authorization list, tap your master
card first and then tap the user cards that you want
to deregister. EVC will play two times long beep after
a successful removal.
c.Charging Authorization
User
Connect the charging cable to your EV and EVC.
EVC waits for the RFID card authorization. Please
tap any of your user cards over the RFID reader sym-
bol. If the card ID is in authorized card list of EVC, it
plays one time beep sound and the charging session
starts immediately. If EVC plays 3 times beep sound
indicating that the tapped user card is not in the local
authorization list, EVC does not allow charging.
d.Resetting RFID Master and User Cards
Switch your EVC device off. For resetting EVC, plea-
se push the button on the EVC for about 10 seconds
while switching on the input power of the EVC. EVC
will play beep sound after a successful reset. Now
the list is reset and you can assign your new master
RFID card in 20 seconds. If you want to use your
EVC as autostart without RFID authorization, please
do not tap any RFID card to the reader during master
card registeration period of 20 seconds after reset.
English - 4 -