Installation Of The Memory Card; Charging The Battery - myPhone FUN 5 Kurzversion Der Bedienungsanleitung

© © © © 2018 2018 mP 2018 2018 mPTech mP mP Tech Tech. All rights reserved. Tech

6.2 Installation of the memory card.

6.2 Installation of the memory card. 6.2 Installation of the memory card. 6.2 Installation of the memory card.
Use only memory cards recommended by the manufacturer. Pay attention to the
selection of the proper format (in this model - the microSD card), capacity and
type/class. Incompatible memory cards may damage the device and cause the stored
data to be destroyed as well. Incompatibility of memory card can be caused, among
others, by an incorrect card format (required format microSD) or an unsupported card
capacity - above the value recommended by the manufacturer.
Turn off the phone to insert the memory card correctly. Subsequently, gently remove
the cover located on the back of the housing, taking care not to damage elements of
the device. Insert the memory card into the slot in accordance to the picture situated
there. Gently replace the cover of the phone.

6.3 Charging the battery

6.3 Charging the battery
6.3 Charging the battery 6.3 Charging the battery
Charge the battery before the first use. The battery should be charged by the attached
charger or another charger, intended for this type of equipment. If in doubt contact
the seller or manufacturer service. Use only chargers and wires recommended by the
manufacturer. Using incompatible chargers or cables can cause explosion of the
battery or damage to your device. When the battery is near complete discharge, the
message is displayed on a low battery charge. To continue use of device charge the
battery. If the battery is completely discharged the device can not be switched on
even when the loading process is ongoing. Before the device can be turned on again,
the battery has to be charged for at least a few minutes. In case of any problems with
the battery or if in need of a replacement, the device should be delivered to the
manufacturer's service center. To charge the battery, connect the microUSB plug to
the socket in the device and the USB plug to the charger.
Incorrect charger connection (USB cable) can cause damage to the AC
adapter or the device
covered by the warranty.
Plug the charger into the wall socket. Once you start charging, an icon of the battery
situated in the upper right corner will change to an animated symbol of lightning. If
the device is turned off an animation depicting the level of battery charge should
appear.
The device can heat up during charging. It is a regular occurrence and should
not affect the stability or performance of the device.
When the charge reaches 100% it means that the battery is fully charged, finish the
charging. Unplug the charger from the from the wall socket and from the smart phone.
If the phone does not charge properly deliver it (with the charger) to a service
center of the manufacturer.
The damages resulting from improper handling are not
.
18
FUN 5 FUN 5 FUN 5 FUN 5