Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3
Installation
3.1 Appropriate installation location
Contact an Authorized Service for the installation
of the product. In order to prepare the product
for use, refer the information in the user manual
and ensure that electrical installation and water
installation are appropriate. If not, call a qualified
electrician and technician to have any necessary
arrangements carried out.
WARNING:
B
shall not be held liable for
damages that may arise from
procedures carried out by
unauthorized persons.
WARNING:
B
be plugged in during installation.
Otherwise, there is the risk of
death or serious injury!
WARNING:
clearance of the room where the
product shall be place is so tight
B
to prevent passing of the product,
remove the door of the room and
pass the product through the
door by turning it to its side; if
this does not work, contact the
authorized service.
• Place the product on an even floor surface to
prevent jolts.
• Install the product at least 30 cm away from
heat sources such as hobs, heater cores and
stoves and at least 5 cm away from electrical
ovens.
• Product must not be subjected to direct sun light
and kept in humid places.
• Appropriate air ventilation must be provided
around your product in order to achieve an
efficient operation. If the product is to be placed
in a recess in the wall, pay attention to leave at
least 5 cm distance with the ceiling and side
walls.
Refrigerator / User Guide
• Do not install the product in places where the
temperature falls below -5°C.
3.2 Installing the plastic wedges
Plastic wedges supplied with the product are
used to create the distance for the air circulation
between the product and the rear wall.
1. To install the wedges, remove the screws on the
product and use the screws supplied together with the
wedges.
Manufacturer
2. Insert the 2 plastic wedges onto the rear ventilation
cover as illustrated in the figure.
Product must not
If the door
7/31EN
Werbung
