grabner TRAMPER Handbuch Seite 6

► Motorised boat suited for electric motors
to max. 2,2 KW/3 HP - With outrigger
only!
ASSEMBly
► Open and empty the carton, of your
TRAMPER and remove backrests and
foot-rests.
► Check the list of items to ensure no parts
are missing.
► Remove the wrapping foil and unroll the
boat.
► Inflate the boat till it reaches approxima-
te final shape.
► Insert the backrests into the backrest
(the backrest-bracket must be positioned
between the 2 bolts of the backrest and
outside the washers), and turn the back-
rest over to the front (short backrest to
the rear, long backrests forward or mid-
ships).
for use the steering device (optional):
► Insert the footrest with foot pedals into
the desired position between the bottom
and the side tubes.
► Now only inflate your boat to full opera-
ting pressure (0.3 bar).
6
DiSMANTliNG
► Choose clean ground for dismantling
and packing.
► Remove all loose parts from the boat
(seats, steering, spray cover, fins and
personal items, ...)
► Deflate the boat.
► Remove the backrests.
► Clean and dry your TRAMPER and the
accessories to avoid damage by grit!
► Check your TRAMPER for possible da-
mage, and repair such as soon as possib-
le, ready for next use!
fOlDiNG iNSTRUCTiONS
► Roll up the boat from bow to stern (di-
rection towards valves) so as to allow
discharge of air.
► Unroll and place the boat flat on the
ground
► Fold the boat in half lengthwise.
► Start firmly rolling the boat from bow to
rear.
► Fold the stern over to the inside of the
roll and continue until finish.